Tag: PDK

Posted on by

Flex 5.32.0.0 Porsche PDK

New Boot Solutions for TCU ZF 8-Speed ​​Porsche and Bentley

Magicmotorsport has released new Boot mode solutions for the latest ZF PDK generation, 8DT TC400 and TC401 automatic transmissions equipped with TC275 microprocessors.

Thanks to the new Boot protocol it’s now possible to access the complete contents of the electronic unit with full read and write access to the Internal Flash and EEPROM memories. This allows any chiptuning or repair work.

Supported Vehicles:

  • Porsche Carrera 911 (922) 3.8L 2021
  • Porsche Panamera (971) 3.0L 2021
  • Bentley Bentayga Speed ​​W12 Twin Turbo 2021
  • Bentley Continental GT W12 Turbo 20200

The new protocols are available for the following software packs:

  • FLS0.10 – SW Flex Infineon TC17xx – TCxxx
  • FLS0.2 – SW Flex TCU OBD/Bench

Read time: ~ 1 minute | Write time: ~ 30 seconds

New Protocols:

  • Porsche ZF TC400 – TC401: Read / Write / Checksum Internal Flash; Read / Write Internal Eeprom; Full Backup
  • Bentley ZF TC400 – TC401: Read / Write / Checksum Internal Flash; Read / Write Internal Eeprom; Full Backup
More info and pricing
Posted on by

bFlash Update V2007A – Porsche PDK OBD

Porsche PDK7 Gearbox solution by OBD!

Q&A

How fast is it?
The calibration write time is around 1 minute.
A full software flash takes around 6 min 30 seconds.
Reading is a virtual read.

 

Do I need to buy an extra bFlash module?
Of course not! This protocol is active now, for all users.

 

How do I connect to the ECU?
You can connect the car through the OBD socket located in the car.

 

What control units are included in this bFlash update?
You can find the full list of control units below.

New TCU OBD Protocols:

PORSCHE

PDK-TC210.g1 – TC1766
PDK-TC210.g2 – TC1766
PDK-TC240 – TC1767

Flashing, datalogging & diagnostics.

All in one tool!

More Info

Posted on by

NEW: Universal Gearbox / TCU Bench Cable

This universal gearbox pin out cable allows you to connect easily and comfortably to most types transmission control units.

The cable is fitted with an OBD2 female plug allowing connection any OBD flash tool.

It features:

  • Female OBD2 port
  • Power connections by 12V (fused) and GND crocodile clips (Power supply not included)
  • LED indicator to confirm when TCU power is ON.
  • Switched Power (ON/OFF)
  • Internal 120Ω CAN bus termination
  • 6 x 12V TCU connectors
  • 6 x GND TCU connectors
  • 3 x CAN H TCU connectors
  • 3 x CAN L TCU connectors
  • 3 x K-Line TCU connectors

Buy Now