OBD Programming with Bench Unlock

New Flex update, version 7.37.0.0, introducing support to Gen 2 Delco Exx control units from the General Motors group, compatible with Delco E41, E46, E88, E90, and E93 (Global A) models.

Programming procedures are carried out in OBD with Bench Unlock, ensuring the highest stability and safety in every step when communicating with the control unit.

Flex automatically identifies memory areas available for reading and enables Read Maps buttons (to access the calibration area) or Read Maps&Code (to access both the calibration area and the Application SW area).

Moreover, the virtual read can be downloaded directly from Magicmotorsport servers, thus optimizing working time and improving the intervention, depending on file availability.

With this new update, Flex extends compatibility further, with new generation Delco ECUs and, as an exclusive, it allows unlock and writing operations with no additional costs, everything is included in your subscription.

New Protocols:

  • GM Delco E41 MPC5676 Virtual Read, Read/Write/Checksum Calculation (Maps & Code Available)
  • GM Delco E46 MPC5777 Virtual Read, Read/Write/Checksum Calculation (Maps & Code Available)
  • GM Delco E88 MPC5777 Virtual Read, Read/Write/Checksum Calculation (Maps & Code Available)
  • GM Delco E90 MPC5777 Virtual Read, Read/Write/Checksum Calculation (Maps & Code Available)
  • GM Delco E93 MPC5777 Virtual Read, Read/Write/Checksum Calculation (Maps & Code Available)

This new protocol is available for the following software packages:

  • FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
  • FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
  • FLS0.5M – SW Flex Full Master
  • FLS0.5S – SW Flex Full Slave