This cable allows you to connect most flash tools to VAG DSG DQ500 controllers. This can used to read the original file direct from the DSG connector.
Connections include power, switched ignition pin and CAN bus.
Universal OBD to DQ500 DSG Cable
Tag: VAG
Universal OBD to DQ200 DSG Tricore Cable
This cable allows you to connect most flash tools to Temic DSG DQ200 controllers and can be used to read out the original file direct from the DSG connector as reading over OBD is not possible.
It can be used to read/write all versions of DQ200 on the bench.
The cable has both K-line and CAN wired (with integral termination resistor) and is fitted with an OBD2 female plug allowing connection any flash tool with an OBD2 cable.
Universal OBD to DQ250 DSG Tricore Cable
This cable allows you to connect most flash tools to Temic DSG DQ250 controllers. This can be used to read out the original file direct from the DSG connector as reading over OBD in tricore versions of DQ250 is not possible (type Exx and Fxx).
It can also be used to read/write all versions of DQ250 on the bench (type Cxx, Exx and Fxx).
The cable has both K-line and CAN wired (with integral termination resistor) and is fitted with an OBD2 female plug allowing connection any flash tool with an OBD2 cable.
CMDFlash VAG / Porsche EDC17CP44 Probe
This BDM Style probe allows reading/writing of VAG / Porsche EDC17CP44 control units without soldering.
No additional resistors or boot pins are required!
It is supplied with a special cable to connect the ecu directly to the CMDFlash Boot Interface. LED lights are fitted to the underside of the probe to aid alignment, Power is supplied by your existing CMD BDM/Tricore power supply.
This kit includes the CP44 probe and cable.
VAG MED17 EDC17 ECU Recovery Service Available
After failed programming due to bad checksum calculation or TPROT protection activation the VAG MEDC17 control unit can “lock”, resulting in the ecu becoming stuck in programming mode and no possibility to complete a write over OBD.
We offer a recovery file service to restore the ecu back to a fully working state.
We can also if required disable on TPROT active ecus the RSA signature check routines allowing flashing of modified files over OBD!
For full infomation please Contact us with full ecu details…