This cable allows you to connect your CMDFlash to Temic DSG DQ200 controllers and can be used to read out the original file when virtual read fails, as reading over OBD is not possible.
It can be used to read/write all versions of DQ200 on the bench.
The cable has both K-line and CAN wired (with integral termination resistor) and is fitted with a DB9 plug for a direct connection to the CMDFlash interface.
This cable allows you to connect your CMDFlash to Temic DSG DQ250 controllers. This can be used to read out the original file when virtual read fails, as reading over OBD in tricore versions of DQ250 is not possible (type Exx and Fxx).
It can also be used to read/write all versions of DQ250 on the bench (type Cxx, Exx and Fxx).
The cable has both K-line and CAN wired (with integral termination resistor) and is fitted with a DB9 plug for a direct connection to the CMDFlash interface.
Module 30 is used for Bosch MEDC17 controllers using password protected TriCore TC17xx processor.
This module allows the reading and writing of flash and eeprom of “almost” all BOSCH EDC17 and MED17 by toolbox. With it is also possible to tune ECU’s which have a so-called Tuning-Protection 8/10. To compute to the checksum module 7 is required.
The module 30 is a pure software module. No additional hardware is included
** To open a slave “.pak” file of module 8, the matching master this module have unlocked also.
Module 9 is used for DSG controllers from Temic with TriCore processor.
Previously it was only possible to flash DSG DQ250 Temic PowerPC (Cxx software). However with module 9 it is now possible to flash also the newer generation of DSG controllers using Tricore processor.
** To open a slave “.pak” file of module 9, the matching master this module have unlocked also.
