Description
The New Genius is the world’s first Touch & Map device which allows reading / programming the ECU in modern vehicles over OBD2.
It is able to work without connection a computer during the critical phases of reading and writing of the ECU, ensuring the process is executed in complete safety. As a completely independent tool, the risks of working with a PC can be avoided, risks such as stalling, Windows crashes, power failure etc…
The New Genius supports CAN-BUS, KWP and J1850 protocols and has communication modules available for the following vehicles:
- Cars
- Bikes
- LCV
- Trucks
- Tractors / Agricultural
- Marine
It is equipped with a sophisticated system for the recovery of the ECU should any problems occur during programming.
The New Genius is controlled through a system of icons from your TOUCH PANEL touchscreen, this makes it extremely easy to use. A standard 16 pin OBD cable is included and specific connectors to work on making diagnosis and special cables to do so through direct connection to the connector or plate ECU.
Key Features:
Easy to use thanks to its touch screen and intuitive menu.
Completely independent of the PC during the phases of read / write.
System automatic backup.
SD 1 GB expandable memory (expandable to 16 GB)
System updates via USB.
Technical Specifications:
ABS plastic enclosure with ergonomic grip system safe.
LCD display 320 x 240 pixels, CCFL back light with Touch Panel.
Flash memory chip 512K bytes protected.
16 MB RAM memory.
SD card of 1 GB expandable.
LED status SD.
Internal clock with memory.
Lithium 3 volts.
Rechargeable battery 600 mAh 8.4V.
Supply voltage from 12V to 30V.
Communication via K line, L line, CAN-bus 2.0 and J1850.
The New Trasdata is a unique tool supporting almost all microprocessors used in the automotive field, for reading and programming operations in JTAG, BDM and BOOT mode.
Developed as the evolution of the hugely successful Trasdata predecessor which was known for it’s ease of use and innovation (e.g. Automatic identification of the plugin required, backup copies of the whole ECU firmware etc…) the New Trasdata opens new doors to JTAG communication, which is widely used Asian vehicles.
A wide range of JTAG developments expands the possibilities of the programmable controllers and of course BDM and BOOT applications are also included. The list of microprocessors now includes:
- Motorola MPC5xx (BDM mode)
- Motorola MC68xxx (BDM mode)
- Motorola MPC55xx (JTAG mode)
- Renesas SH705x (AUD/BOOT mode)
- Mitsubishi MH72xx/MH82xx (BOOT mode)
- Infineon Tricore (BOOT mode)
- ST Microelectronics ST10xxx (BOOT mode)
- Motorola HC12 (BDM mode)
- Renesas M32R (BOOT mode)
- NBD NEC M32R (Toyota TF010 CPU Group)
Using the New Trasdata allows you also widen the range of vehicles supported by New Genius via OBDII.
When the ECU microprocessor is delivered with “anti-tuning/TPROT” protection, a software patch can be applied using New Trasdata which unlocks the OBDII communication and allows programming with New Genius once again.
Also supported is reading and programming of the whole content of the ECU (microprocessor, flash Eprom and serial Eeprom). A wide variety of operations are therefore supported and after the initial reading, it is always possible to restore the ECU to it’s original state. Automatic checksum correction is performed in the writing operation.
These operations can be performed without any physical soldering if desired, a wide range of programming adapters are available to allow connection between the New Trasdata and the ECU with our BDM positioning frame.
