Description
Software module or reading and writing on the Bench through CAN-bus for diesel and petrol vehicles with Magneti Marelli ECUs.
An approved J2534* and a BitSoftware Senselock USB dongle are required in order to use this software!
* Attention! It needs to connect ECU on the bench with any adapter with automatic power management (SM2 bench cable, BITS001, Powerbox, etc…)
Magneti Marelli MPC5XXX BENCH-CAN (FID: 460)
This ECU is based on MCU Infineon SAK-XC2785X-104F80L with internal flash memory 832Kb.
Allows to read Full Flash and write calibration area by OBD2. Supports 1.6 CFNA, CFNB, CLRA, CLSA and 1.4 CGGB, CLPA, CLPB engines.
It writes calibration area and takes only 3 minutes.
Magneti Marelli IAW 7GVE (FID: 71)
It allows:
- Software identification
- Full Flash reading
- Full Flash writing
- Flash CS fix on writing
- Recovery
- EEPROM reading and writing
Supported ECU types:
- MJD 8F2 – MPC5565 + 95640
- MJD 8F3 – MPC5565 + 95640
- 8GMC – MPC5565 + 95128
- 8GMK – SPC564A80 (MPC5644) + 95128
- 8GMW – MPC5565 + 95128
- 8GSF – MPC5565 + 95640
- 9GF – SPC564A70 (MPC5642) + 95640
- 10JA – MPC5777 + 95128
