Module 12 “Honda / Acura CAN-bus” added support for ECU Continental LuK-UDCT used in Honda vehicles. Writing, checking and correction of checksums is supported.
Module 28 “VAZ / UAZ”, explicit support for the ME17.9.7 ECU with a diagnostic protocol working via the CAN bus has been added.
Module 30 “Kia / Hyundai SIM2K” added support for reading, writing, checking and correcting the CS of the calibration area of the SIM2K-141.1 ECU.
Module 35 “Toyota / Lexus / Scion / Hino” supports the ECU of the 8-speed automatic transmission Aisin based on the 70F4019 microcontroller used in the Lexus LX570 vehicle. Writing, checking and correction of the checksums is supported.
Module 41 “Scania EMS / EDC S6” the problem of writing in some modes, which appeared in version 1.2.2, has been resolved.
Module 51 “China” adds support for Chery MED17.8.10 ECU used to control F4J16 engines.
Module 53 “Infineon Tricore BSL” added support for the ECU of the robotic gearbox SIM2K-305.
Module 58 “VAG DSG / CVT” added support for ECU Continental LuK-UDCT in service mode, used in Honda vehicles. It supports reading, writing FLASH and EEPROM, as well as checking and correcting FLASH checksums .
Module 69 “Mercedes-Benz MED17 / EDC17” a test protocol for the ME9.7 ECU has been added, reading, writing, checking and correcting the checksums is supported.
Module 76 “Kia / Hyundai Gearbox” added test support for the ECU of the robotic gearbox SIM2K-305, it supports reading (when directly connected to the ECU), writing (modified files – only after unlocking by module 53), checking and correcting the CS.
Module 77 “Bosch ME9 / MED9 / EDC16 Bootloader” added support for ECU PSG16, EEPROM 95080, extended support for CS.
