Iveco Bosch MD1CS069 Added!

Release 7.49.0.0 of Flex allows OBD programming for the most modern Iveco vehicles equipped with Bosch MD1CS069, even those produced after 2021.

Thanks to this new protocol, you can now work directly from the diagnostic port of the vehicle (bypassing the SGW module), or establishing direct connection through the connector.

As of today, working on the map area doesn’t require unlocking the control unit nor shipping it to us: remove DTCs, boost engine performance, or cut consumption, all in a few minutes.

Iveco Bosch MD1CS069 TC299 Read/Write/Checksum Calculation Maps

Some of the supported vehicles:

  • Iveco Daily (IV) 2.3L FPT 16v 134HP

  • Iveco Daily (IV) 3.0L FTP 16v 177HP

This new protocol is available for the following software packages:

  • FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
  • FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
  • FLS0.5M – SW Flex Full Master
  • FLS0.5S – SW Flex Full Slave