Fomoco UTCU3 TCUs Now Covered

New version 7.47.0.0 of Flex out now, introducing a new protocol dedicated to Fomoco UTCU3 TCUs installed on Ford vehicles with 6, 8, and 10-speed automatic transmissions.

With the new Flex release, you can perform OBD programming of a wide range of vehicles that are equipped with this control unit, by connecting directly to the diagnostic port.

Operating in OBD means getting quick access to the map area, making it possible to carry out necessary modifications to optimize transmission performance.

Ford Fomoco UTCU3 TC277 Read/Write/Checksum Calculation Maps

Some of the supported vehicles:

  • Ford Bronco (VI) (2020MY) 2.7L Ecoboost V6 335PS

  • Ford Kuga (III) (2020MY) 1.5L EcoBoost 150PS

  • Ford Ranger T6 (2019MY) 2.3L Ecoboost 270PS

This new protocol is available for the following software packages:

  • FLS0.2M – SW Flex TCU OBD/Bench Master
  • FLS0.2S – SW Flex TCU OBD/Bench Slave
  • FLS0.5M – SW Flex Full Master
  • FLS0.5S – SW Flex Full Slave