Tag: INVCON3.3

Posted on by

Flex 5.28.0.0 Hybrid + E Vehicles!

Bench solutions for Hybrid and Full Electric Vehicles

The latest release of FLEX opens up Bench mode reprogramming of inverter modules and automatic transmissions on hybrid and full electric Volkswagen, Audi, and Jaguar vehicles.

The FLEX version 5.28.0.0 protocols allow access to the Bosch INVCON3.3 (TC275), INVCON2.3 (TC1797), and Bosch VC1CP103 (TC277) control units directly from the module connector and therefore guarantee repair reliable repair and performance tuning.

Supported Vehicles:

  • Audi A3 8V 1.4 TFSI E-Tron (MY2018)
  • Audi A3 8V 1.4 TFSI E-Tron (MY2012)
  • Golf VII GTE 1.4 TSI Hybrid (MY2018)
  • Golf VII GTE 1.4 TSI hybrid (MY2012)
  • Jaguar I-Pace EV400 (MY2019)

The new protocols are available for the following software packs:

  • FLS0.1 – SW Flex ECU (cars, vans, bikes) OBD + Bench
  • FLS0.10 – SW Flex Infineon TC17xx Master
  • FLS0.5 – Package Flex FULL

Read time: ~ 50 seconds | Write time: ~ 40 seconds

NEW BENCH PROTOCOLS:

  • Volkswagen BOSCH INVCON2.3: Read / Write / Checksum Internal Flash; Read / Write / Checksum internal EEPROM; Full backup
  • Audi BOSCH INVCON2.3: Read / Write / Checksum Internal Flash; Read / Write / Checksum internal EEPROM; Full backup
  • Volkswagen BOSCH INVCON3.3: Read / Write / Checksum Internal Flash; Read / Write / Checksum internal EEPROM; Full backup
  • Audi BOSCH INVCON3.3: Read / Write / Checksum Internal Flash; Read / Write / Checksum internal EEPROM; Full backup
  • Jaguar BOSCH VC1CP103: Read / Write / Checksum Internal Flash; Read / Write / Checksum Internal EEPROM; Full Backup

 

More info and pricing
Posted on by

BitBox 3.3.6 rev 1

New module:

  • BOSCH MG1/MD1 BENCH is now ready for sales and has been already tested. We remind that module works only with Scanmatik2/Scanmatik2 Pro devices and requires the latest driver version 2.21.11. List of tested ECU types you can check on our website! All other ECUs were not tested and will be supported ASAP. FID 282: Bosch MG1/MD1 SPC/AURIX BENCH with reading/writing and checksums calculation.
  • VAG Continental Simos12.1 now ready for tests, please contact BitBox support if you would like to beta test

Fixes and improvements:

  • Bosch INVCON3.3 support added to Bosch MG1/MD1 Bench
  • Delphi MT05 read/clear DTC has been returned
  • Kia/Hyundai SIM2K-25X/26X now works with Scanmatik2/Scanmatik2Pro. We recommend to use them.
  • PSA Continental SID208 now works with Scanmatik2/Scanmatik2Pro, other devices are also supported but not properly tested.

More Info

View Full Range of modules here.

bitbox_logo