Description
Software module for reading and writing ECUs used in diesel GM vehicles (Chevrolet, Opel, Saab, Holden).
*The J2534 Tactrix Openport 2.0 interface and a BitSoftware Senselock USB dongle are required in order to use this software!
GM Bosch EDC16C39 HW1 (FID: 65).
ECU is based on MCU Motorola MPC562 with external flash memory 2.0Mb.
Allows to read and write calibration area through CAN-bus with checksum correction on writing.
Chevrolet Captiva 2.0 VCDI
Chevrolet Cruze 2.0 VDCI
Chevrolet Epica 2.0 VCDI
Chevrolet Lacetti 2.0 VCDI
Daewoo Winstorm 2.0 VCDI
Opel Antara 2.0 CDTI
Opel Astra (H) 1.9 CDTI
Opel Combo (D) 1.6 CDTI
Opel Signum 1.9 CDTI
Opel Vectra (C) 1.9 CDTI
Opel Zafira (B) 1.9 CDTI)
GM Bosch EDC16C39 HW2 (FID: 67).
ECU is based on MCU Motorola MPC562 with external flash memory 2.0Mb.
Allows to read and write calibration area through CAN-bus on the bench with checksum correction on writing.
Chevrolet Trailblazer II 2.8TD Duramax
Holden Colorado 2.8TD Duramax
GM ACDelco E87 (FID: 90)
ECU is based on MCU Motorola MPC5565 with internal flash memory 2.0Mb.
Allows to read and write calibration area through CAN-bus on the bench with checksum correction on writing.
GM ACDelco E98 (FID: 85)
ECU is based on MCU Motorola SPC5674 with internal flash memory 4.0Mb.
Allows to read and write calibration area through CAN-bus on the bench with checksum correction on writing.
GM Delphi DCM3.7AP (FID: 317)
The control unit is based on a Renesas SH72544 processor with an internal flash memory of 2.0Mb.
Allows reading and writing of the calibration area via CAN-bus with checksum correction.
